Posts Tagged ‘Water meter’June 25, 2015
Your water meter is read each month to determine your water consumption. Meters are typically located in your basement, although most residential and commercial meters are read by remote equipment which does not require Des Moines Water Works staff to enter your home or business. Each month, your meter read is displayed on the bottom of your statement. If your meter is easily accessible, you can read the water meter yourself to verify the reads against your statement.
The readings are displayed like the odometer on your car and read from left to right. Most meters in Des Moines measure in cubic feet, and typically reflect six digits. The first four digits on the meter are shown verbatim on your statement (exception: any leading zeroes are omitted). However, Des Moines Water Works bills only in hundred cubic feet increments, so the last two digits on your statement will always be “00,” regardless of what is shown on your meter.
If you notice your water bill is the same amount some months, it is not uncommon and can occur especially for customers who are fairly consistent water users. It occurs because Des Moines Water Works bills in 100 cubic foot increments. Although your actual water consumption does in fact vary from month to month, the meter must “roll over” to a new hundred cubic feet before you are charged for the last 100 cubic feet. For example, if your meter read is 173934 as shown in the illustration, you would not be charged for any additional consumption until the meter rolls over to the next hundred cubic feet, which would be a meter read of 174000. It is important to note that 100 cubic feet is equivalent to 748 gallons, which means that if you are within 748 gallons of last month’s consumption, your charges could be identical despite slightly different usage from one month to the next.
Des Moines Water Works’ automated radio frequency meter reading equipment in most of our service areas allows Des Moines Water Works to receive two meter reads each day, and these reads are available to you via your online account at www.dmww.com.
If your consumption is higher than expected, you can monitor your daily reads at any time by querying your meter reading data on our website. If, after monitoring your daily consumption, you believe you may have a leak, call a customer service representative at (515) 283-8700 to discuss what may be causing the high consumption.
Des Moines Water Works (DMWW) provides water to its customers and maintains the water mains required to deliver water to homes and businesses. DMWW also owns the water meter used to measure consumption. Property owners are responsible for the connection (tap) to the water main and the piping (service line) that carries water from the main to the meter. The property owner is also responsible for protecting and providing access to the water meter. When a problem occurs, DMWW staff will assist the property owner in determining the cause of the problem and the appropriate course of action.
What is a stop box?
The stop box houses the valve used to turn the water service on and off to a property. It is usually located in the public right of way. DMWW requires that the stop box be operable at all times.
Who owns the stop box?
The property owner owns the stop box and is responsible for its repair.
How does the stop box operate?
To operate the stop box, a long key is placed inside the housing and lowered onto the valve to turn the water service on or off. Sometimes, due to age or damage, the stop box does not operate, requiring repair.
Why is the stop box operated?
DMWW will operate the stop box:
- to terminate service at the owner’s request when a property is sold.
- to cut water service for internal plumbing repairs.
- at a rental property to discontinue water service when the tenant is moving.
- when a customer fails to make timely payment on their water bill.
Sometimes a stop box needs to be repaired. What are the reasons for repair?
- When the stop box is too high or too low. The top of the stop box should be level with the ground.
- If the stop box is located under concrete or asphalt, a repair must be made so that the stop box is accessible.
- If the housing for the stop box becomes bent and the key cannot be lowered into the housing.
- If the rod is loose in the stop box and does not connect to the valve.
- When the valve does not operate.’
Who will make the repairs?
DMWW is not licensed to make plumbing repairs and we recommend that you contract the services of a licensed plumber. If you do not make repair arrangements, DMWW will contract the services of a plumber and bill the charges to your account.
How much will it cost for repairs?
The cost will depend on the work required to make the repair.
What if my service line starts to leak?
Please notify DMWW if you notice water leaking and our representative will assist in determining the location of the leak. Sometimes it is difficult to determine the source of the leaking water as it follows the path of least resistance and does not always come to the surface right near the leak. Once located, the property owner will be notified to contact a licensed plumber to make repairs to the leaking service line.
What if my service line starts to leak and water is not coming to the surface of the ground?
During our routine leak survey of the distribution system, using electronic leak detection equipment, leaks are sometimes located that don’t come to the surface. Our leak detection personnel will attempt to determine the source of leaking water and inform you of its general location.
Who is responsible for the water meter?
The water meter is usually located in the basement or in a meter pit outside the building. The property owner is responsible for protecting the meter from freezing temperatures and providing access to the meter and meter reading equipment. The water meter is owned by DMWW.
If you need additional assistance, please call (515) 283-8771.